Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Generator Set Specifications
- Maximum Rating
- 100 ekW
- Minimum Rating
- 72 ekW
- Emissions/Fuel Strategy
- U.S. EPA Cert., Tier 3
- Voltage
- 110 to 480 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- Cat® C4.4
- Bore
- 4.1in
- Stroke
- 5in
- Displacement
- 268.5in³
- Compression Ratio
- 16.2:1, 17.25:1, 18.2:1 or 18.3:1
- Aspiration
- Turbocharged
- Fuel System
- Direct Injection or Common Rail
- Governor Type
- Mechanical
Generator Set Dimensions
- Length - Maximum
- 75.8in
- Width - Maximum
- 44.1in
- Height - Maximum
- 53.6in
Standard Equipment:
- Air Inlet System
- Air cleaner; light duty with disposable element
- Cooling System
- Radiator and cooling fan with guards
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Caterpillar extended life coolant
- Control Panel
- GCCP 1.3
- Exhaust System
- Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank
- Generator
- Voltage regulator (single phase sensing)
- 12 Leads
- IP23 Protection
- Circuit breaker, IEC, 3 pole, mounted in tower panel
- Segregated low voltage (AC/DC) wiring panel
- Tower panel, IP22, bottom cable entry
- Governing System
- Mechanical and electrical governing system - model dependent
- Lube System
- Oil drain line with valve
- Lubricating oil
- Mounting System
- Termination points for coolant and lube oil drain lines
- Includes lifting provision and drag points
- Captive linear vibration isolators between base and engine-generator
- Starting/charging System
- 24V battery with rack and cables
- Batteries
- General
- Engine and alternator pre-paint, Caterpillar yellow
Optional Equipment:
- Alternator System
- Permanent magnet excitation (PMG)
- R Frame auxilliary winding
- Anti-condensation heater
- R Frame auxilliary winding
- Quadrature droop kit
- LC Frame alternator with coastal insulation protection
- 3 phase sensing
- Circuit Breakers
- Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A
- Cooling System
- Low coolant level shutdown
- Coolant heater
- Low coolant temperature alarm
- Control Panel Options
- GCCP 1.3
- Control panel heater
- Earth leakage (2 wire only)
- Panel mounted audible alarm
- Volt free contacts
- Emergency stop with key
- Battery charger
- Overload shutdown via breaker
- Speed adjust potentiometer
- Voltage adjust potentiometer
- Enclosures
- Sound attenuated Level 2 enclosure
- Sound attenuated Level 1 (galv)
- Rental pack - CAE rental option only
- European Certifications
- Upgrade to STD set for CE
- Fuel System
- Skidbase for CALG enclosure sets
- Low fuel level alarm
- Open set narrow tankbase
- Low fuel level shutdown
- Compact skidbase for open set
- High fuel level alarm
- Bunded fuel tank
- Global Certifications
- Certification for CIS
- Mounting Options
- Electronic governor
- Industrial silencer
- External single point lift - enclosure
- Battery removal
- Silencer installation kit
- Special Packing/inspectons For Shipment
- PGS Test report @ 0.8 power factor
- PGS Test report @ 1.0 power factor
- General - Accessories / Miscellaneous
- Packing case - compact set
- Packing case - canopied set
- Stone guards/rad trans flange
Specifications
Generator Set Specifications
- Maximum Rating
- 100 ekW
- Minimum Rating
- 72 ekW
- Emissions/Fuel Strategy
- U.S. EPA Cert., Tier 3
- Voltage
- 110 to 480 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- Cat® C4.4
- Bore
- 4.1in
- Stroke
- 5in
- Displacement
- 268.5in³
- Compression Ratio
- 16.2:1, 17.25:1, 18.2:1 or 18.3:1
- Aspiration
- Turbocharged
- Fuel System
- Direct Injection or Common Rail
- Governor Type
- Mechanical
Generator Set Dimensions
- Length - Maximum
- 75.8in
- Width - Maximum
- 44.1in
- Height - Maximum
- 53.6in
Standard/Optional Features
Standard Equipment:
- Air Inlet System
- Air cleaner; light duty with disposable element
- Cooling System
- Radiator and cooling fan with guards
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Caterpillar extended life coolant
- Control Panel
- GCCP 1.3
- Exhaust System
- Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank
- Generator
- Voltage regulator (single phase sensing)
- 12 Leads
- IP23 Protection
- Circuit breaker, IEC, 3 pole, mounted in tower panel
- Segregated low voltage (AC/DC) wiring panel
- Tower panel, IP22, bottom cable entry
- Governing System
- Mechanical and electrical governing system - model dependent
- Lube System
- Oil drain line with valve
- Lubricating oil
- Mounting System
- Termination points for coolant and lube oil drain lines
- Includes lifting provision and drag points
- Captive linear vibration isolators between base and engine-generator
- Starting/charging System
- 24V battery with rack and cables
- Batteries
- General
- Engine and alternator pre-paint, Caterpillar yellow
Optional Equipment:
- Alternator System
- Permanent magnet excitation (PMG)
- R Frame auxilliary winding
- Anti-condensation heater
- R Frame auxilliary winding
- Quadrature droop kit
- LC Frame alternator with coastal insulation protection
- 3 phase sensing
- Circuit Breakers
- Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A
- Cooling System
- Low coolant level shutdown
- Coolant heater
- Low coolant temperature alarm
- Control Panel Options
- GCCP 1.3
- Control panel heater
- Earth leakage (2 wire only)
- Panel mounted audible alarm
- Volt free contacts
- Emergency stop with key
- Battery charger
- Overload shutdown via breaker
- Speed adjust potentiometer
- Voltage adjust potentiometer
- Enclosures
- Sound attenuated Level 2 enclosure
- Sound attenuated Level 1 (galv)
- Rental pack - CAE rental option only
- European Certifications
- Upgrade to STD set for CE
- Fuel System
- Skidbase for CALG enclosure sets
- Low fuel level alarm
- Open set narrow tankbase
- Low fuel level shutdown
- Compact skidbase for open set
- High fuel level alarm
- Bunded fuel tank
- Global Certifications
- Certification for CIS
- Mounting Options
- Electronic governor
- Industrial silencer
- External single point lift - enclosure
- Battery removal
- Silencer installation kit
- Special Packing/inspectons For Shipment
- PGS Test report @ 0.8 power factor
- PGS Test report @ 1.0 power factor
- General - Accessories / Miscellaneous
- Packing case - compact set
- Packing case - canopied set
- Stone guards/rad trans flange