Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Generator Set Specifications
- Maximum Rating
- 715 kVA
- Minimum Rating
- 550 kVA
- Emissions/Fuel Strategy
- Low Fuel, EU Stage IIIA
- Voltage
- 380 to 415 Volts
- Frequency
- 50 Hz
- Speed
- 1500 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
- Bore
- 5.71in
- Stroke
- 7.2in
- Displacement
- 1106.4in³
- Compression Ratio
- 14.5:1
- Aspiration
- Air to Air Aftercooled
- Fuel System
- Electronic unit injection
- Governor Type
- Adem™A4
Generator Set Dimensions
- Length - Minimum
- 218.5in
- Length - Maximum
- 218.5in
- Width - Maximum
- 80.9in
- Height - Maximum
- 107.8in
Standard Equipment:
- Air System
- Air cleaner, light duty
- Turborcharger
- Air Inlet
- Air cleaner
- Control Panel
- GCCP 1.3
- GCCP Genset Controller
- Cooling
- Package mounted radiator
- Cooling System
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Radiator and cooling fan with guard
- Caterpillar extended life coolant
- Exhaust
- Exhaust flange outlet
- Exhaust System
- Stainless steel exhaust flex, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied Base, formed steel with single wall integral 8-hour fuel tank
- Fuel
- Fuel priming pump
- Secondary fuel filters
- Primary fuel filter with integral water separator
- Generator
- Matched to the performance and output characteristics of Cat engines
- IP23 Protection
- Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
- Generator And Attachments
- Segregated low voltage (AC/DC) wiring panel
- Power center, IP22
- Optional LC Frame generator - IP23 Protection,
- Mandatory option rear circuit breaker, IEC, 3 pole, mounted in power center
- Integrated voltage regulator (IVR)
- A Frame generator - IP21 Protection
- Governing System
- Cat electronic governor (ADEM A4)
- Power Termination
- Busbar
- Lube System
- Oil drain valves
- Lubricating oil
- Mounting System
- Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
- Starting / Charging
- 24 Volt battery with rack and cables
- Starting/charging
- 24 volt starting motor
- Batteries
- Mounting
- Rubber vibration isolators
- General
- Engine and alternator pre-paint, Caterpillar yellow
- Paint - Caterpillar yellow except rails and radiators gloss black
Optional Equipment:
- Certifications
- Global
- European Certifications - EU Certificate of Conformance (CE)
- Exhaust
- Industrial, residential, critical mufflers
- Air Inlet System
- Dual element air cleaner
- Single element air cleaner
- Generator
- Oversize and premium generators
- Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
- Anti-condensation heater
- Power Termination
- Circuit breakers, IEC compliant
- Circuit breakers, UL listed
- Circuit Breakers
- 4 Pole (IEC-100% rated) - package mounted
- 3 Pole (IEC-100% rated) - package mounted
- Padlockable device
- 4 Pole (IEC-100% rated) - motorized
- Power terminal strip
- 3 Pole (IEC-100% rated) - motorized
- Control Panel
- GCCP 1.4
- Control Panels
- Local & remote annunciator modules
- Digital I/O module
- Load share module
- EMCP (4.2) (4.3) (4.4)
- Remote monitoring software
- Control System
- Local alarm modules
- Control panel protective devices
- Remote annunciator module
- Volt free contacts
- Cooling System
- Radiator duct flange
- Enclosures
- Sound attenuated enclosures
- Starting/charging
- Heavy duty starting system
- Battery chargers
- Charging alternator
- Oversize batteries
- Jacket water heater
- Exhaust System
- Elbow Kit
- Mufflers - End in/end out
- Manifold and turbocharger guards
- Engine mounted muffler
- Flange groups; 8 and 10 inch weld flanges and gaskets
- Fuel System
- Integral dual wall fuel tank base
- Manual fuel transfer system
- Fuel transfer system
- General
- Integral & sub-base UL listed dual wall fuel tanks
- UL 2200 package
- Narrow, wide or skid base
- Enclosures: Sound attenuated, weather protective
- Sound attenuated, weather protective or high ambient weather protective enclosure
- EEC Declaration of Conformity
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- The following options are based on regional and product configuration:
- Single or dual wall sub-base fuel tanks
- Automatic transfer switches (ATS)
- CSA Certification
- EU Certificate of Conformance (CE)
- Single or dual wall integral fuel tanks
- Generator And Attachments
- A Frame CIP generator
- LC frame generator
- Permanent magnet excitation (PMG)
- LC frame oversize generator
- Space heaters
- Ingress protection
- LC frame CIP generator
- A Frame oversize generator
- Lube System
- Manual sump pump
- Mounting System
- Narrow skid base
- Starting / Charging System
- 5 Amp Battery charger
- Jacket water heater
- Battery disconnect switch
Specifications
Generator Set Specifications
- Maximum Rating
- 715 kVA
- Minimum Rating
- 550 kVA
- Emissions/Fuel Strategy
- Low Fuel, EU Stage IIIA
- Voltage
- 380 to 415 Volts
- Frequency
- 50 Hz
- Speed
- 1500 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
- Bore
- 5.71in
- Stroke
- 7.2in
- Displacement
- 1106.4in³
- Compression Ratio
- 14.5:1
- Aspiration
- Air to Air Aftercooled
- Fuel System
- Electronic unit injection
- Governor Type
- Adem™A4
Generator Set Dimensions
- Length - Minimum
- 218.5in
- Length - Maximum
- 218.5in
- Width - Maximum
- 80.9in
- Height - Maximum
- 107.8in
Standard/Optional Features
Standard Equipment:
- Air System
- Air cleaner, light duty
- Turborcharger
- Air Inlet
- Air cleaner
- Control Panel
- GCCP 1.3
- GCCP Genset Controller
- Cooling
- Package mounted radiator
- Cooling System
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Radiator and cooling fan with guard
- Caterpillar extended life coolant
- Exhaust
- Exhaust flange outlet
- Exhaust System
- Stainless steel exhaust flex, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied Base, formed steel with single wall integral 8-hour fuel tank
- Fuel
- Fuel priming pump
- Secondary fuel filters
- Primary fuel filter with integral water separator
- Generator
- Matched to the performance and output characteristics of Cat engines
- IP23 Protection
- Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
- Generator And Attachments
- Segregated low voltage (AC/DC) wiring panel
- Power center, IP22
- Optional LC Frame generator - IP23 Protection,
- Mandatory option rear circuit breaker, IEC, 3 pole, mounted in power center
- Integrated voltage regulator (IVR)
- A Frame generator - IP21 Protection
- Governing System
- Cat electronic governor (ADEM A4)
- Power Termination
- Busbar
- Lube System
- Oil drain valves
- Lubricating oil
- Mounting System
- Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
- Starting / Charging
- 24 Volt battery with rack and cables
- Starting/charging
- 24 volt starting motor
- Batteries
- Mounting
- Rubber vibration isolators
- General
- Engine and alternator pre-paint, Caterpillar yellow
- Paint - Caterpillar yellow except rails and radiators gloss black
Optional Equipment:
- Certifications
- Global
- European Certifications - EU Certificate of Conformance (CE)
- Exhaust
- Industrial, residential, critical mufflers
- Air Inlet System
- Dual element air cleaner
- Single element air cleaner
- Generator
- Oversize and premium generators
- Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
- Anti-condensation heater
- Power Termination
- Circuit breakers, IEC compliant
- Circuit breakers, UL listed
- Circuit Breakers
- 4 Pole (IEC-100% rated) - package mounted
- 3 Pole (IEC-100% rated) - package mounted
- Padlockable device
- 4 Pole (IEC-100% rated) - motorized
- Power terminal strip
- 3 Pole (IEC-100% rated) - motorized
- Control Panel
- GCCP 1.4
- Control Panels
- Local & remote annunciator modules
- Digital I/O module
- Load share module
- EMCP (4.2) (4.3) (4.4)
- Remote monitoring software
- Control System
- Local alarm modules
- Control panel protective devices
- Remote annunciator module
- Volt free contacts
- Cooling System
- Radiator duct flange
- Enclosures
- Sound attenuated enclosures
- Starting/charging
- Heavy duty starting system
- Battery chargers
- Charging alternator
- Oversize batteries
- Jacket water heater
- Exhaust System
- Elbow Kit
- Mufflers - End in/end out
- Manifold and turbocharger guards
- Engine mounted muffler
- Flange groups; 8 and 10 inch weld flanges and gaskets
- Fuel System
- Integral dual wall fuel tank base
- Manual fuel transfer system
- Fuel transfer system
- General
- Integral & sub-base UL listed dual wall fuel tanks
- UL 2200 package
- Narrow, wide or skid base
- Enclosures: Sound attenuated, weather protective
- Sound attenuated, weather protective or high ambient weather protective enclosure
- EEC Declaration of Conformity
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- The following options are based on regional and product configuration:
- Single or dual wall sub-base fuel tanks
- Automatic transfer switches (ATS)
- CSA Certification
- EU Certificate of Conformance (CE)
- Single or dual wall integral fuel tanks
- Generator And Attachments
- A Frame CIP generator
- LC frame generator
- Permanent magnet excitation (PMG)
- LC frame oversize generator
- Space heaters
- Ingress protection
- LC frame CIP generator
- A Frame oversize generator
- Lube System
- Manual sump pump
- Mounting System
- Narrow skid base
- Starting / Charging System
- 5 Amp Battery charger
- Jacket water heater
- Battery disconnect switch