Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Generator Set Specifications
- Maximum Rating
- 60 ekW
- Minimum Rating
- 36 ekW
- Emissions/Fuel Strategy
- U.S. EPA Cert., Tier 3
- Voltage
- 208 to 600 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- C4.4, In-line 4, 4-cycle diesel
- Bore
- 4.13in
- Stroke
- 5in
- Displacement
- 268.5in
- Compression Ratio
- 18.2:1
- Aspiration
- Turbocharged
- Fuel System
- Electronic (adjustable)
- Governor Type
- Adem™A4
Generator Set Dimensions
- Length - Maximum
- 75.8in
- Width - Maximum
- 44.1in
- Height - Maximum
- 53.6in
Standard Equipment:
- Certificates
- IBC seismic and wind Certifications
- Charging System
- NFPA battery charger UL10A 120VAC
- Air Inlet System
- Air cleaner
- Cartridge type air filter
- Circuit Breakers
- Second circuit breaker box
- 3-Pole 100% rated
- Power terminal strip
- Breakers (100% UL rated)
- Control Panel
- 1000028996
- Exhaust System
- Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank
- Cooling System
- Coolant drain line with valve
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
- Caterpillar extended life coolant
- Radiator stone guard
- Generator
- 12 Leads
- Governing System
- Mechanical and electrical governing system - model dependent
- Lube System
- Oil drain line with valve
- Lubricating oil
- Control Panels
- WCA1 Low coolant temperature alarm
- WSS1 Low coolant level shut down
- FSS Low fuel level alarm & indication panel circuitry required when sub-base tank is selected
- NFPA110 bundle includes:
- PAA1 Panel mounted audible alarm
- A Coolant heater, remote annunciator or 0.8 power factor test may be required depending on the application
- Oil temperature gauge and sender
- PBC10NU NFPA battery charger
- Ground fault relay
- Discrete I/O module
- Volt free contacts genset run and common alarm
- Audible alarm
- Remote E-stop button
- Remote annunciator module
- Low coolant temperature alarm
- Protective devices:
- Overload shutdown via breaker
- Fuel level reading
- Low coolant level shutdown
- General
- Engine and alternator pre-paint, Caterpillar yellow
- Starting/charging System
- 24V battery with rack and cables
- Batteries
Optional Equipment:
- Certificates
- IBC seismic and wind Certifications
- Alternator System
- R Frame auxilliary winding
- Air Inlet System
- Cartridge type air filter
- Charging System
- NFPA battery charger UL10A 120VAC
- Circuit Breakers
- 3-Pole 100% rated
- Breakers (100% UL rated)
- Second circuit breaker box
- Power terminal strip
- Control Panels
- Discrete I/O module
- Remote annunciator module
- Remote E-stop button
- Protective devices: Low coolant temperature alarm - Low coolant level shutdown - Fuel level reading - Overload shutdown via breaker
- Ground fault relay
- Audible alarm
- Oil temperature gauge and sender
- Volt free contacts genset run and common alarm
- NFPA110 bundle includes: FSS Low fuel level alarm & indication panel circuitry required when sub-base tank is selected - WSS1 Low coolant level shut down - WCA1 Low coolant temperature alarm - PAA1 Panel mounted audible alarm - PBC10NU NFPA battery charger - A Coolant heater ,remote annunciator or 0.8 power factor test may be required depending on the application
- Heating Elements
- Coolant heater
- Battery heater
- Anti-condensation heater
- Lube oil sump heater
- Jacket water heater
- Wiring for canopy space heater
- Cooling System
- Radiator transition flange
- Enclosures
- Panel viewing window
- External emergency stop
- Sound attenuated enclosure, Level 2
- Weatherproof enclosure
- Sound attenuated enclosure, Level 1
- Fuel System
- 5 Gallon fill containment
- Tank riser
- 209 and 394 gallon sub-base fuel tanks
- Emergency vent pipe
- 5 Gallon spill containment
- Mounting System
- Seismic vibration isolators
- Tests
- Generator test report
- PGS Test report @ 0.8 power factor
- 4 Hour factory test
- PGS Test report @ 1.0 power factor
- Exhaust System
- 10, 25 and 35 dBA silencer systems
- Overhead silencer mounting kit
- Generators
- Permanent magnet excitation (PMG) generator
Specifications
Generator Set Specifications
- Maximum Rating
- 60 ekW
- Minimum Rating
- 36 ekW
- Emissions/Fuel Strategy
- U.S. EPA Cert., Tier 3
- Voltage
- 208 to 600 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- C4.4, In-line 4, 4-cycle diesel
- Bore
- 4.13in
- Stroke
- 5in
- Displacement
- 268.5in
- Compression Ratio
- 18.2:1
- Aspiration
- Turbocharged
- Fuel System
- Electronic (adjustable)
- Governor Type
- Adem™A4
Generator Set Dimensions
- Length - Maximum
- 75.8in
- Width - Maximum
- 44.1in
- Height - Maximum
- 53.6in
Standard/Optional Features
Standard Equipment:
- Certificates
- IBC seismic and wind Certifications
- Charging System
- NFPA battery charger UL10A 120VAC
- Air Inlet System
- Air cleaner
- Cartridge type air filter
- Circuit Breakers
- Second circuit breaker box
- 3-Pole 100% rated
- Power terminal strip
- Breakers (100% UL rated)
- Control Panel
- 1000028996
- Exhaust System
- Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
- Fuel System
- Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank
- Cooling System
- Coolant drain line with valve
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
- Caterpillar extended life coolant
- Radiator stone guard
- Generator
- 12 Leads
- Governing System
- Mechanical and electrical governing system - model dependent
- Lube System
- Oil drain line with valve
- Lubricating oil
- Control Panels
- WCA1 Low coolant temperature alarm
- WSS1 Low coolant level shut down
- FSS Low fuel level alarm & indication panel circuitry required when sub-base tank is selected
- NFPA110 bundle includes:
- PAA1 Panel mounted audible alarm
- A Coolant heater, remote annunciator or 0.8 power factor test may be required depending on the application
- Oil temperature gauge and sender
- PBC10NU NFPA battery charger
- Ground fault relay
- Discrete I/O module
- Volt free contacts genset run and common alarm
- Audible alarm
- Remote E-stop button
- Remote annunciator module
- Low coolant temperature alarm
- Protective devices:
- Overload shutdown via breaker
- Fuel level reading
- Low coolant level shutdown
- General
- Engine and alternator pre-paint, Caterpillar yellow
- Starting/charging System
- 24V battery with rack and cables
- Batteries
Optional Equipment:
- Certificates
- IBC seismic and wind Certifications
- Alternator System
- R Frame auxilliary winding
- Air Inlet System
- Cartridge type air filter
- Charging System
- NFPA battery charger UL10A 120VAC
- Circuit Breakers
- 3-Pole 100% rated
- Breakers (100% UL rated)
- Second circuit breaker box
- Power terminal strip
- Control Panels
- Discrete I/O module
- Remote annunciator module
- Remote E-stop button
- Protective devices: Low coolant temperature alarm - Low coolant level shutdown - Fuel level reading - Overload shutdown via breaker
- Ground fault relay
- Audible alarm
- Oil temperature gauge and sender
- Volt free contacts genset run and common alarm
- NFPA110 bundle includes: FSS Low fuel level alarm & indication panel circuitry required when sub-base tank is selected - WSS1 Low coolant level shut down - WCA1 Low coolant temperature alarm - PAA1 Panel mounted audible alarm - PBC10NU NFPA battery charger - A Coolant heater ,remote annunciator or 0.8 power factor test may be required depending on the application
- Heating Elements
- Coolant heater
- Battery heater
- Anti-condensation heater
- Lube oil sump heater
- Jacket water heater
- Wiring for canopy space heater
- Cooling System
- Radiator transition flange
- Enclosures
- Panel viewing window
- External emergency stop
- Sound attenuated enclosure, Level 2
- Weatherproof enclosure
- Sound attenuated enclosure, Level 1
- Fuel System
- 5 Gallon fill containment
- Tank riser
- 209 and 394 gallon sub-base fuel tanks
- Emergency vent pipe
- 5 Gallon spill containment
- Mounting System
- Seismic vibration isolators
- Tests
- Generator test report
- PGS Test report @ 0.8 power factor
- 4 Hour factory test
- PGS Test report @ 1.0 power factor
- Exhaust System
- 10, 25 and 35 dBA silencer systems
- Overhead silencer mounting kit
- Generators
- Permanent magnet excitation (PMG) generator